During your first installation process please follow the introduction guide carefully!
In your mobile app, make sure the gateway is in pairing mode by going to Sensors -> Temperature -> Add new sensor.
How to Pair your Sensor (only briefly, for more details please refer to the instructions shown on the mobile application during the pairing process)
- Remove the battery stripe from the back. This will make the sensor enter pairing mode.
- OR take the pin needle, insert it into the hole next to the LED on the bottom left of the sensor, press it lightly once, the LED should stop blinking.
- Wait for the LED to stop blinking.
- Tap the next button in your mobile app.
- Give your sensor a name.
- If the pairing fails then please try again.
Placing
- It is recommended to place the sensor with the provided glue stripe.
- It is not recommended to place the sensors in places where the temperature is expected to be bellow -10°C or above 50°C.